Difference between P-Trap and S-Trap

Main difference

The main difference between P-trap and S-trap is that the length of bottom tubing used in P-traps is p-shaped while the length of bottom tubing used in S-traps is S-shaped.

P-Trap vs S-Trap

P-traps are the traps that are p-shaped, that is, when the water passes through these pipes, the little water is reserved, while the bottom traps used in S-traps are S-shaped. In the P-trap, the sewage is reserved for a small interval, while in the s-trap the sewage is reserved. The small amount of water is passed through the p-trap, while in the S-trap a large amount of water is required to remove the debris. The p-trap is the preferred one these days, while the S-trap is generally used less nowadays. The P-trap is smaller, while the S-trap is slightly larger than the normal P-trap. In the P-trap, there is no need for the sink to save water, however, in the s-trap, water is needed in the sink to drain the debris. The P-trap is a new technique for the drainage system, while the S-trap was installed in an older build. There is no odor in the p-trap installation due to the small water reservoir in the sink, while in the tarpaulin the odors from the drains are reserved in the pipes that cause different diseases. Properly maintained p-traps generally do not require maintenance or replacement, while S-traps require very frequent maintenance. In the p-trap, the malodour order problem does not usually occur, while in the S-trap it usually does. The p-trap is built to vent through the wall; in hand, the S trap is designed to vent through the floor. while in the S trap it used to happen. The p-trap is built to vent through the wall; in hand, the S trap is designed to vent through the floor. while in the S trap it used to happen. The p-trap is built to vent through the wall; in hand, the S trap is designed to vent through the floor.

Comparison chart

p trap strap
The p-shaped trap is called a p-trap. And cheat means double The s-shaped trap is called an s-trap. Trap means double
reserved waste
Little water is reserved in the siphon sink p In s trap, wastewater is reserved
Waste of water
The small amount of water is used to drain the debris. A large amount of water is often used to drain off the residue.
Preference
A p-trap is more preferred these days The S-trap isn’t usually the go-to these days.
Size
A p trap is usually small than the S trap The S trap is usually larger than the p trap.
The sink needs to save water
In the p trap, the sink does not need to save water. In s trap, the sink needs to save water
Bad smell
No odor at p-trap installation Bad smell comes out in the installation of the trap s
Maintenance
In p-trap, no regular maintenance is required In S-trap it is kept very often
Installation
In p-trap, the outlet of the drainage system is installed on the wall In S-trap the outlet of the drainage system is installed on the ground

What is the P trap?

The p-shaped pipe bend is called a p-trap. The P-trap is more preferred now than other traps. You do not need to reserve water in your sink. It is installed on walls. You don’t need a lot of water to drain the waste. Plumbers preferred this trap nowadays. In the p-trap, the sewage in the sink causes the bad smell. It does not need daily maintenance like in other traps. The p-trap size is small and can be easily installed. In the p-trap, the outlet is installed on the walls. The p trap is a new technique for the drainage system. In p-trap setup, the small place region is required. The p trap is smaller. Requires bending over the toilet pipe and going into the wall. The water reserved in the p-trap does not produce a bad smell. In the p-trap,

What is S Trap?

The S-trap is the S-shaped trap. A trap is considered to be a bend in the toilet pipe. The S-trap was used in elderly buildings. Reserve water in the sink pipe as sewage. S trap was used to install on the floor. It needs a large amount of water to drain the water. The plumber used this drainage system in the old days. In the s-trap, the reserved sewage causes the bad smell in a bathroom. Its bad order causes different diseases. The S-trap requires some regular replacement, repair, and maintenance. In s trap, the big place is required. The s trap is used in the old technique drainage system. Requires bending over the toilet pipe and sank into the floor. The s-trap is slightly larger than other traps. It does not cause a bad smell in bathrooms. We need a large amount of water to drain the waste. It is usually installed on bathroom floors.

Key differences

  1. The P-trap is the p-shaped toilet bend, while the S-trap is the S-shaped toilet pipe bend.
  2. The P trap is used in buildings today; on the other hand, S-trap is in old buildings.
  3. P-trap requires a large amount of water to drain debris; conversely, the s-Strap used a small amount of water to drain debris.
  4. In the P-trap, little water is reserved and it does not cause a bad smell in the bathroom; on the other hand, the reserved S-trap water causes the bad smell in the bathroom.
  5. The P-trap is usually small in size, while the S-trap is usually larger.
  6. The P-trap is shaped like a P and is installed on walls, while the S-trap is shaped like an S and is installed on floors.

Final Thought

From the above discussion, it is concluded that the P-trap is usually installed in new buildings, while the S-trap is usually installed in older buildings. They both have a different structure and require different amounts of water to drain the waste.

Leave a Reply

Your email address will not be published. Required fields are marked *

CAPTCHA


Back to top button